10 Series Power Supply Options
The 10 Series Power Supplies distribute a single low voltage DC output. The PDM-4, PDM-4C, PDM-8 and PDM-8C boards are available separately and can be used to customize your power supply after installation.
• Power switch to shut off all devices for
servicing on PDM-4 and 4C only
• Converts a single input to 4 separately
protected outputs
• Available with fuses (PDM-4) or PTC circuit
breakers (PDM-4C)
• Separate green power indicator LED for each
output
 |
The PDD-FT board is a fire panel control interface. This board can be used to control DC output based on a fire alarm control panel. Two outputs switch state on alarm. |
 |
The PDD-8PCI board is a power distribution/control interface. The board can be used to convert a DC power source to 8 Class II power limited outputs that can be controlled by a fire alarm control panel. This board allows the installed to power electromagnetic locks, electric strikes, DC Camera and access control with the same power supply. |
|
|
The PDM-4, PDM-4C, PDM-8 and PDM-8C boards distribute a single low voltage AC or DC source into 4 or 8 outputs. The output voltage and total current available is determined by the input supply. When installed into a power supply, servicing time can be greatly reduced by the output indicator LED's. If an output fuse is blown or PTC is tripped the accompanying LED will be off, simply identifying the device connected to this output will allow for a problem to be quickly corrected. In addition to short circuit protection, the input terminals also have a surge protector that can absorb a 1500 Watt spike or surge to protect connected devices. |
